Transmission Line Examples 2.10 2000/08/04 2007/08/14 13:20:37.949 GMT-5 Bill Wilson wlw@madriver.net Bill Wilson wlw@madriver.net Elizabeth Gregory elizabeth.gregory@gmail.com Jeffrey M Silverman JSilverman@astro.berkeley.edu Gerard Wysocki gerardw@rice.edu relative dielectric constant stripline transmission line This module examines a stripline, one example of a transmission line. As an example, and also because it even has some practical importance, let's look at one kind of transmission line. It is called a stripline and it looks like . It consists of a flat conductor, located between two ground planes. It is supported by an insulating dielectric with dielectric constant ε. This is kind of like the situation you would find on a multi-level PC board, where perhaps the bus lines would be running on an inner layer with ground planes above and below them.

A Stripline

Between the center conductor and the ground plane, there will be some capacitance, C. If we can assume that the electric field is more or less confined to the regions between the strip conductor and the ground plane (which occurs when the ratio of W B is not too small) then for either capacitor (assuming unit length into the picture) we will get a value C ε W B 2 since the value of a capacitor is just the dielectric constant times the area of the plates, divided by the spacing of the plates. Looking quickly at you might think the two capacitors are in series, but you would be wrong! Note that each capacitor has one lead connected to the center conductor and the other lead connected to ground, and so the two capacitors are in fact, in parallel, and hence their capacitances add. Thus, for the capacitance per unit length for this line, we can write: C 4 ε W B It can be shown (although we won't do it here) that for any transmission line where the electric and magnetic fields are perpendicular to one another (called TEM or transverse electromagnetic) the speed of propagation of the wave down the line is just v p c ε ε 0 3 10 8 m s ε r Where ε r is called the relative dielectric constant for the material. Well, we also know that v p 1 L C From which we can write L 1 v p 2 C B v p 2 4 ε W We can now insert this value for L into the expression for Z 0 , the impedance of the line. Z 0 L C B v p 2 4 ε W 4 ε W B B 4 ε W v p B 4 ε W c ε r And so, we have derived an equation for the impedance Z 0 of the line in terms of the dimensions W and B, the dielectric constant of the insulating material, ε, and c, the speed of light. How good is this expression, and in particular how good is our assumption that the electric field is all confined to the region under the conductor? Not so great actually .

Exact and Approximate Impedance For a Stripline Exact and approximate Z 0 for a stripline

shows the results from using and a more exact calculation, which takes into account the fringing fields. As you can see we have to get the ratio W B up to about 4 or so before the two match. But at least we get the right behavior and we're not totally out of the ball park.